German RepRap X400CE, Руководство пользователя

Страница: 74 / 245

X400CE 3D Printer Manual
Seite: 69/245
Stand: 2015/08/28 11:55
© German RepRap GmbH 69/245
Number Description
1
X-axis hollow shaft, short, 500 mm
2 Ball bearing LM12UU
1 Carriage Chain Mount
Additional parts for the Dual-Extruder
Number Description
2 Carriage clamp LM12UU
2 Ball bearing LM12UU
The additional parts for the Dual-Extruder are marked with a blue rectangle.
The “Carriage Clamp LM12UU” and the ball bearings are slipped onto the shafts. Afterwards, the long
shaft is inserted at the top, as shown in the image “Finish”. The short shaft is inserted at the bottom.
In the front of the picture you see a configuration for single extruder, in the back a dual extruder.
It is easier to mount the hollow shafts if the corresponding holes are manually reamed with
a 12mm drill. The holes where purposely designed smaller to reach a better accuracy of fit
with manual reaming.
It is important that the shaft holders are not tightened yet, as the X-axis has to be slipped on the
Y-axis guiding rods first.
Finish Y-axis carriage
X-axis carriage