German Light Products GT-1, Руководство пользователя

Страница: 7 / 40

German Light Products
®
GT-1 User Manual
7
Fire safety and protection from burns
•
Do not operate the product if the ambient temperature (Ta) exceeds 45° C (115° F).
• The surface of the product’s casing can reach up to 65° C (149° F) during operation.
Avoid contact by persons and materials. Do not install the product in a location
where there is a risk of accidental contact. Allow the product to cool for at least 20
minutes before handling
•
Keep the product well away from flammable materials.
•
Keep all combustible materials (e.g. fabric, wood, paper) at least 0.2 m (8 in.) away
from the product.
•
Ensure that there is free and unobstructed airflow around the product. Provide a
minimum clearance of 100 mm (4 in.) around fans and air vents.
•
Do not illuminate surfaces within 16 m (52.2 ft.) of the product. The light output from
the product is powerful enough to cause burns or fire in illuminated objects at close
range.
• Do not place any optical components other than GT-1 accessories from GLP onto the
front of the fixture.
•
Do not stick filters, masks or other materials onto the fixture. Do not block the light
output in any way. The front surface becomes hot during operation and can melt or
ignite objects that are in contact with the surface. Ensure that the front surface Is
clean and unobstructed at all times in order to prevent a fire hazard and damage to
the fixture.
•
The product’s optical components can focus the sun’s rays, creating a risk of fire and
damage. Do not expose the front of the product to sunlight or any other intense light
source, even from an angle.
Eye safety
•
The GT-1 is classified as a Risk Group 2 lighting fixture according to EN 62471. Possibly
hazardous radiation emitted. Do not stare into the light output from the product. May
be harmful to the eyes.
•
Do not look at the product’s light output with optical instruments or any device that
may concentrate the light output.
•
Make sure that persons near to or working on the product are not looking directly into
the light output when the product lights up suddenly. This can happen when power is
applied, when the product receives a DMX signal, or when certain control menu
items are selected.
•
Provide well-lit conditions to reduce the pupil diameter of anyone working on or near
the product.