German Light Products GT-1, Руководство пользователя

Страница: 6 / 40

www.glp.de
6
GT-1 User Manual
manual and then use the fixture’s control panel to check the version installed in the
fixture. If the versions are not the same, this manual may still cover the fixture,
because software updates do not always affect the use of the fixture. However, it is
possible that this manual does not match the fixture perfectly. Software release notes
can help clarify this question. You can consult software release notes and download
the correct version of this manual on the GLP website if necessary.
•
Make all user documentation available to all installers and operators. Save user
documentation for future reference.
•
If you have any questions about the safe operation of the product, please contact
an authorized GLP distributor (see list of distributors at www.glp.de).
•
Use the product only as directed in this manual. Observe all markings in this manual
and on the product.
• Refer all repairs and any service operation not described in this manual to a
technician authorized by GLP.
•
Read and follow the user documentation for all additional equipment.
Electrical safety
• Do not allow the product to come into contact with water or moisture.
•
Use only a source of AC mains power that complies with local building and electrical
codes and has both overload and ground fault (earth fault) protection.
•
Ensure that the product is electrically connected to ground (earth).
•
Disconnect the product from AC mains power before carrying out any installation or
maintenance work and when the product is not in use.
•
Disconnect the product from power immediately if any seal, cover, cable, connector
or other component is damaged, defective, deformed or showing signs of
overheating. Do not reapply power until the product has been repaired and made
safe by a technician authorized by GLP.
•
Check that all power distribution equipment, cables and connectors are in perfect
condition, rated for the electrical requirements of all connected devices, suitable for
their application and suitable for the installation environment.
•
Use only a Neutrik PowerCON cable connector for AC mains power input at the
product’s Mains IN connector.
•
Use a power cable that is minimum 14 AWG or 1.5 mm
2
, minimum 16 A-rated and
temperature-rated to suit the application. In the USA and Canada the cables must
be UL-listed, type SJT or equivalent. In the EU the cables must be type H05VV-F or
equivalent.
•
Disconnect the fixture from power before attempting to replace the main fuse.
Replace the fuse with one of the specified type only (see the product specifications
at the end of this manual).