Chapter 5
62
Printing Jobs on the Gerber CAT | UV
P83173A RevA
7/19/10
7
When the first side is complete, flip the
sign blank over left to right (if the top of
the job is located at the front of the printer
as shown in the previous illustration).
Place the sign blank in the same location as
the first side, completely inside the
masking tape and scrap material. Repeat
printing on this side.
8
Remove all masking tape and scrap
material so that the ink does not build up
too high and scratch the heads.
NOTE: The scrap material on the back and
right sides of the sign blank should be removed
after every job; the masking tape at the edges of
the table can be used a few times since it is
thinner than the sign blank. Just be sure to
remove and replace the tape whenever the ink buildup starts
to approach the height of (or is higher than) the
sign blank on which you are printing.
