Genie Nano-CL C2450, Руководство пользователя

Страница: 48 / 118

46
•
Operational Reference Genie Nano-CL Series™
Level Low LevelLow The trigger is considered valid on the low level of
the line source signal.
Trigger Delay TriggerDelay Specifies the delay in microseconds to apply after
receiving the trigger and before activating the
triggerEvent. (min=0, max=2000000)
1.00
Beginner
Trigger Overlap TriggerOverlap States if a trigger overlap is permitted with the
Active Frame readout signal. This feature defines if
a new valid trigger will be accepted (or latched) for
a new frame.
1.00
Guru
Off Off No trigger overlap is permitted.
ReadOut ReadOut Trigger is accepted immediately after the start of
the readout.
End Of Exposure EndOfExposure Trigger is accepted immediately after the previous
exposure period. This will latch the Trigger and
delay the Exposure if the end of that exposure is
shorter than the previous readout.
Line Selector LineSelector Selects the physical line (or pin) of the external
device connector to configure.
1.00
Beginner
CC1 CC1 Select the Camera Link CC1.
CC2 CC2 Select the Camera Link CC2.
Line Name lineName Description of the physical Pin associated with the
logical line.
1.00
Beginner
DFNC
Camera Control 1 CC1 Camera Control 1 of the Camera Link connector
Camera Control 2 CC2 Camera Control 2 of the Camera Link connector
Line Format LineFormat Specify the current electrical format of the selected
physical input or output.
1.00
Expert
LVDS LVDS The line accepts LVDS level signals.
Opto-Coupled OptoCoupled The line is opto-Coupled.
Line Status LineStatus Returns the current status of the selected input or
output line.
1.00
Expert
False The Line is logic LOW
True The Line is logic HIGH
Line Status All LineStatusAll Returns the current status of all available line
signals, at time of polling, in a single bitfield. The
order is Line1, Line2, Line3, ...
1.00
Expert
Line Inverter LineInverter Control to invert the polarity of the selected input
or output line signal.
1.00
Beginner
False / True
Input Line Debouncing
Period
lineDebouncingPeriod Specifies the minimum delay before an input line
voltage transition is recognizing as a signal
transition.
1.00
Beginner
DFNC
Line Mode LineMode Reports if the physical Line is an Input or Output
signal..
1.00
Invisible
Input Input The line is an input line.
Output Output The line is an output line.
Input Line Detection Level lineDetectionLevel Specifies the voltage threshold required to
recognize a signal transition on an input line.
1.00
Invisible
DFNC
Threshold for TTL Threshold_for_TTL A signal below 0.8V will be detected as a Logical
LOW and a signal greater than 2.4V will be
detected as a Logical HIGH on the selected input
line.
Burst Frame Count AcquisitionBurstFrameCount Sets the maximum number of frames to acquire
when a valid trigger is received. This feature is
used when the Trigger Selector is set to
FrameBurstStart.
1.00
Invisible
Line Pinout linePinAssociation Enumeration of the physical line (or pin) on the
device I/O connector. (RO)
1.00
Invisible
Pin5=Signal – Pin3=Gnd Pin5Signal_Pin3Gnd Pin 5 is the Input Signal and Pin 3 is the common
input Ground on the I/O connector.