NOTICE
IF DOOR BE
COMES OB
STRUCTED
PULL DOW
N ON HAND
LE
TO RELEASE CARRIAGE:
1. Pull handle DOWN then let go.
2. Manually move door until carriage releases from bullet.
3.
Raise
or
lower
door
manually.
DOOR
PULL
TO RECONNECT CARRIAGE:
1. Verify RED block is in the
UP
position.
2. Manually move door until carriage engages bullet.
3. Raise or lower door using remote or wall console.
Release
Handle
DISENGAGE
ENGAGE
(for installation)
TO REENGAGE PULL
DOWN AND TOWARD
POWERHEAD THEN
LET GO
(for installation)
TO DISENGAGE
PULL DOWN AND
TOWARDS DOOR
THEN LET GO
DOOR
TO RELEASE or RECONNECT CARRIAGE,
PULL DOWN AND LET GO
DOOR
FIG. 6-4 Carriage Release
(cut away view)
CARRIAGE ENGAGE/DISENGAGE
Use Release Handle to manually connect or release
chain or belt bullet to Carriage.
FIG. 6-3 Carriage Release
CHANGE LIGHT BULBS
WARNING
• Observe all safety warning and precautions!
Improper light bulb removal or replacement
could result in Death or Serious Injury.
• Disconnect power from opener before
beginning this task.
• When replacing light cover, make sure wires are
not pinched or near moving parts.
1.
Disconnect power to door opener.
• Open powerhead light cover.
• Remove light bulb(s).
• Replace with maximum 100 Watt light bulb(s).
–
Do NOT
use light bulbs with greater than
100 Watt rating.
• Close powerhead light cover.
2.
Reconnect power to door opener.
• Test light operation.
©2010 The Genie Company
12/2010
19
RESET - OPEN/CLOSE TRAVEL LIMIT
Performing
all ten (10) Limits/Force setting steps
(pages 6-7) erases previous Limits/Force settings.
NOTE: The opener will not close the door
automatically unless the Safe-T-Beam® System is
installed and Limits are programmed.
MOTION DETECTOR* - OVERVIEW
(Not available on all models)
Powerheads equipped with a motion detector
sensor provide additional security when
exiting or entering the garage area.
*This sensor works by detecting body heat. Range of detection may be
reduced when the temperature in the garage is close to body temperature.
NOTE:
Detector positioning on the powerhead provides
for monitoring
below
the powerhead.
OPERATION
• Detector sensor is always
ON
. There are
NO
user
controls or adjustments.
• Lights automatically turn
ON
when a change is
detected and will turn
OFF
after 4 minutes of no
change.
• Motion detector sensor will not turn
OFF
lighting
turned
ON
at the wall
console
.
• Lighting turned
ON
at the wall console will remain
ON
until wall
console
turns lighting
OFF
or opener
is used.
Motion Detector
