©2010 The Genie Company
12/2010
15
OVERVIEW - REMOTES AND OPTIONS
5
FCC and IC CERTIFIED
This device complies with FCC Part 15 and RSS
210 of Industry Canada. This equipment has been
tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide
reasonable protection against harmful interference
in a residential installation. This equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not
occur in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which may be determined
by turning the equipment OFF and ON, the user is
encouraged to try to correct the interference by
one or more of the following measures:
• Re-orient or relocate the receiver antenna.
• Increase the separation between the opener and
receiver.
• Connect the opener into an outlet on a circuit
different from that to which the receiver is
connected.
• Consult your local dealer.
FIG. 5-1 Remote
WARNING
A moving door can cause serious injury or death.
1.
Keep people clear of opening while door is
moving.
2.
Do
NOT
allow children to play with opener,
including wall console, remote, or wireless
keypad.
3.
During programming, the door opener could
begin to run, so keep people and objects away
from the moving door and its parts. To keep the
door from moving, close the door and disconnect
it from the rail carriage by pulling the Emergency
Release Handle. See page 19 for Release Handle
operation.
Three Button
Remote
See page 21 for battery changing instructions.
LOST OR STOLEN REMOTE - CLEARING MEMORY
Clearing remotes from powerhead memory will
clear ALL programmed remotes and wireless
keypad.
NOTE:
Follow the PROGRAM REMOTE TO
POWERHEAD steps to re-enter remaining or new
remotes. See page 9.
1.
Press
PROGRAM
SET
and hold
until both lights
come ON
BLUE.
Release button.
2.
Lights go out and Round
BLUE
light comes ON.
3.
Press
PROGRAM
SET
again and
long LED flashes
PURPLE
.
PROGRAM
SET
—
+
PROGRAM
SET
—
+
4.
Press both and
simultaneously on the
powerhead and hold until
both LEDs flash
BLUE.
• Verify memory is cleared. Press a remote
button that was previously programmed to
the powerhead. Remote will not activate door
opener.
• Garage door opener will operate normally using
wall console.
• Program remaining or new remotes as shown
on page 9.
Your door opener will no longer
recognize any signal received from the missing
remote, or any other which has not been
reprogrammed to the powerhead.
PROGRAM
SET
—
+
