Page
C-6
OPERATING INSTRUCTIONS
Document 57.0008.5200 - 10/2006
Handler with telescopic boom
GTH-3007
C-2.2 ADJUSTING THE SEAT
A correct adjustment of the seat ensures the operator
a safe and comfortable driving. The handler seat is
fitted with devices which allow for the adjustment of
the springing, the height and the distance from the
controls.
•
Seat distance from the controls
The seat is equipped with an adjusting device to
slide the same seat forward or back with respect to
the steering column.
To adjust the seat, pull lever
1
outwards and push the
seat to the desired direction. Then release the lever
and make sure that the seat locks in position.
•
Springing adjustment
Rotate lever
2
clockwise or anticlockwise according
to the springing degree required. Rotate clockwise/
anticlockwise to increase/reduce the seat springing.
To reverse this control, pull out and rotate the lever
knob by 180°.
•
Height adjustment
Turn knob
3
clockwise to lift the seat; turn it counter-
clockwise to lower the seat.
In some seats height can be adjusted to three
different positions. Lift the seat until you hear the
click signalling that the seat is locked in position.
To lower the seat, raise to end of stroke to release
the mechanism, then release the seat: it will return
to the bottom position.
DANGER
DANGER
ELECTRICAL
DANGER
PROTECT THE
ENVIRONMENT
ATTENTION
CAUTION
IMPORTANT
DANGER
DANGER
ELECTRICAL
DANGER
PROTECT THE
ENVIRONMENT
ATTENTION
CAUTION
IMPORTANT
The seat is for one person only.
Don’t adjust the seat when the machine is
moving.
C-2.3 FASTENING THE SEAT BELTS
Sit correctly in the driving seat; then:
• The safety belts are equipped with reel retractor. To
fasten the belt, pull tab
1
and push it into buckle
2
.
• To release the belt, push button
3
and remove the
tab from the buckle.
• make sure that the buckle is correctly located at the
hip point and not on the stomach.
• operate the end adjusters to reach the length you
wish and make sure the buckle is always in the
middle.
