Geniewatch, NSD5451 User Manual (Ver. 1.0)
Genie Network
20
3
Operation
3.1
Check points before operation
-
Before power is applied, please check the cables carefully.
-
The camera ID of the controller must be identical to that of the target camera. The camera
ID can be checked by reading DIP switch of the camera.
-
If your controller supports multi-protocols, the protocol must be changed to match to that
of the camera.
-
If you changed camera protocol by changing DIP switch, the change will be effective after you
reboot the camera.
-
Since the operation method can be different for each controller available, refer to the
manual for your controller if camera can not be controlled properly. The operation of this
manual is based on the standard Pelco® Controller.
3.2
Preset and Pattern Function Pre-Check
-
Check
how to operate preset and pattern function with controller or DVR in advance to
operate camera function fully when using controller or DVR.
-
Refer to the following table when using standard Pelco® protocol controller.
< Go Preset >
Input [Preset Number] and press [Preset] button shortly.
< Set Preset >
Input [Preset Number] and press [Preset] button for more than 2
seconds.
< Run Pattern >
Input [Pattern Number] and press [Pattern] button shortly.
< Set Pattern >
Input [Pattern Number] and press [Pattern] button for more than 2
seconds.
-
If controller or DVR has no pattern button or function, use shortcut keys with preset
numbers. For more information, refer to “Reserved Preset
”
in this manual.
