Genie CCTV Raptor II Ruggedized PTZ, Инструкция по эксплуатации

Страница: 42 / 48

Genie Raptor Manual Ver. 3.1 42 Edition. GN-April-2013
• ALARM IN
Move to the PRESET by the detection of an ALARM INPUT from an external sensor.
How to set up PRESET
1. Move to ALARM IN, press IRIS OPEN KEY. The menu below is displayed.
2. Set a PRESET number.
3. Move to EXIT and press the RIGHT KEY to finalise the set up.
•
TIME OUT
Set a TIME OUT to determine the waiting time from PRESET to the reactivation of a TOUR
after an ALARM IN has been received.
Caution
1. PRESET DEFINE must be set to ON to activate ALARM IN.
2. A ground signal from an external alarm must be maintained for a minimum of 200ms.
6. WIPER SET
AUTO: WIPER is activated at TILT angle within 80°~100°.
PUSH: WIPER is activated once.
RUN: WIPER ON
STOP: WIPER OFF
Select the menu using the Joystick and press the IRIS OPEN to activate.
1. IN1 PRESET NUM OFF / 1~128
2. EXIT
7. INITIALISE SET
1. POWER ON RESET
2. PAN/TILT INIT
3. CAMERA INIT
4. AUTO SEQ INIT
5. PRIVACY ZONE INIT
6. FACTORY INIT
7. EXIT