GEA T.VIS M-20 FDD, Инструкция по эксплуатации

Страница: 47 / 58

3.
Grip the sensor module (43) by the mountain bracket and take out of the base
(5). Ensure ESD-compliant handling.
®
Done
Hint!
Fit the sensor module in the reverse order. Observe the wiring
diagrams, see Page 18
10.6.5 Removing the pneumatic block
Requirement:
• If only O-rings (42) and (55) are to be changed, solenoid valves (63) / valve
plate (65) can remain on the pneumatic block (8).
Carry out the following steps:
1. Undo the screws (57.1, 57.2).
Fig.20
2. Pull off the pneumatic block (8).
3.
Change the 6 O-rings (42) of the base (5).
4. Replace the O-ring (55).
®
Done
10.6.6 Fitting the Pneumatic Block
Requirement:
• When fitting the pneumatic block, make sure that it is compatible!
Maintenance
Dismantling the Control Top into its Components
430BAL014475EN_2
03.09.2021 47