Instructions for use and maintenance
This manual is owned by GEA Niro Soavi Any reproduction, even partial, is prohibited.
07C100-7C0
GEA Niro Soavi
189
The type of construction, the high quality materials used and the care taken in assembly by highly
skilled personnel guarantee great reliability and a long duration.
Proper lubrication is critical to the long life of the transmission assembly and its components: make
sure you observe the specified change intervals, along with the fluid levels and lubricant types.
In normal conditions, the crank gear system requires no maintenance. If you encounter abnormal
noise or uneven operation of the machine, contact the
GEA Niro Soavi S.p.A.
Service Department
for technical assistance.
Under normal conditions of operation and with no faults, with reference to Figure 7-39, it is
recommended to check the bushes of the crank gear system
(14)
, of the pin
(11)
and of the relevant
bush on the connecting rod
(13)
at least every approximately 10,000 hours of operation, and of
the roller bearings
(4)
of the crankshaft at least every approximately 20,000 hours of operation.
These operations must be done by skilled personnel, so it is recommended to contact the Technical
Service Department at
GEA Niro Soavi S.p.A.
for information and support. The only scheduled
maintenance operations concern the replacement of the guide piston gaskets
(16)
and
(18),
if any
leaks of lubricating oil are noticed in the sump.
If the surface of the guide piston where the gasket runs is very scored, the guide pistons must be
replaced.
This operation must be done by skilled personnel, so it is recommended to contact the Technical
Service Department at
GEA Niro Soavi S.p.A.
for information and support.
CAUTION:
Lubricating oil is highly polluting. Do not dump it in the environment or in drains, but collect
it in special containers for disposal.
At least partially drain off the oil in the body to prevent it accidentally coming out
Содержание Niro Soavi One7TS
Страница 2: ......
