Instructions for use and maintenance
This manual is owned by GEA Niro Soavi Any reproduction, even partial, is prohibited.
07C100-7C0
GEA Niro Soavi
164
Instructions for assembly
For assembly proceed as follows:
- insert the gasket
(7)
in its housing in the flange or in the head; it is recommended to use food-
grade Vaseline or a suitable lubricant to facilitate assembly operations
- prepare the seat
(6)
for assembly, with inside it the ball
(5)
and with the O-Ring
(8)
- fit the flange
(3)
on the valve body
(2)
and position the two half-rings
(4)
to hold the flange in place
- insert the seat
(6)
already prepared on the valve body and, holding it in position with your fingers,
fit the whole valve onto the housing flange
- insert the flange
(3)
on the studs and screw on the nuts
(1)
by hand so as to block the valve
correctly, fitting the seat
(6)
onto the O-Ring
(7)
- when the valve is in a stable position, before tightening the nuts
(1)
, correctly position the discharge
pipe. For safety reasons the discharge pipe must always be open and pointing downwards
- fully tighten the nuts
(1)
.
FIG. 7-29
Содержание Niro Soavi One7TS
Страница 2: ......
