GE MultiLink ML810, Инструкция по эксплуатации

Страница: 200 / 348

12–4 MULTILINK ML810 MANAGED EDGE SWITCH – INSTRUCTION MANUAL
CONFIGURING STP CHAPTER 12: SPANNING TREE PROTOCOL (STP)
forwarding state. The default is 15 seconds, with a range of 4 to 30 seconds.
• Root Bridge Hello Time : Indicates the designated root bridge's hello time. Hello
information is transmitted every 2 seconds.
• Root Bridge Max Age : Indicates the designated root bridge maximum age, after
which it discards the information as being old and receives new updates.
These variables can be changed using the “priority”, “cost”, “port” and “timers” commands
described later in this chapter.
Example 12-2 illustrates the
show stp
command with the
ports
parameter. The variables
listed in this example are defined as follows:
•
Port#
: indicates the port number. Value ranges from 01 to max number of ports in
the switch
•
Type
: indicates the type of port - TP indicates Twisted Pair
Example 12-1: Viewing STP configuration
ML810# show stp config
RSTP CONFIGURATION
-----------------
Rapid STP/STP Enabled(Global) : NO
RSTP/STP Enabled Ports : 1,2,3,4,5,6,7
Protocol : Normal RSTP
Bridge ID : 80:00:00:00:00:00:00:00
Bridge Priority : 32768
Bridge Forward Delay : 15
Bridge Hello Time : 02
Bridge Max Age : 20
Root Port : 0
Root Path Cost : 0
Designated Root : 80:00:00:00:00:00:00:00
Example 12-2: Viewing STP ports
ML810# show stp ports
STP Port Configuration
-------------------------------------------------------------------------------
Port# Type Priority Path Cost State Des. Bridge Des. Port
-------------------------------------------------------------------------------
01 TP(10/100) 128 100 Disabled 80:00:00:20:06:2b:e1:54 80:01
02 TP(10/100) 128 100 Disabled 80:00:00:20:06:2b:e1:54 80:02
03 100MB Fiber 128 100 Disabled 80:00:00:20:06:2b:e1:54 80:03