GE Multilin F650, Руководство пользователя

Страница: 97 / 323

GEK-106310AE F650 Digital Bay Controller 3-31
3 HUMAN INTERFACES. SETTINGS & ACTUAL VALUES 3.1 ENERVISTA 650 SETUP SOFTWARE INTERFACE
3
3.1.9 ACTUAL VALUES MENU OVERVIEW
The menu bar in the main screen of EnerVista 650 Setup software shows the ACTUAL menu option. This option
concentrates and displays all the status of protection, control elements, metering, counters information, oscillography,
events, fault locator, etc. This section shows only the structure of menus in EnerVista 650 Setup.
Table 3.18: GENERAL OVERVIEW OF ACTUAL VALUES MAIN MENU:
3.1.9.1 FRONT PANEL
The front panel menu shows only the LEDs submenu where all the front LEDs can be monitored.
3.1.9.2 STATUS
The following menu includes all the available protection status in the device. Location of different menus could vary
depending firmware version.
Table 3.19: GENERAL OVERVIEW OF STATUS MENU:
ACTUAL
Front Panel The relay front LEDs status is shown on this menu.
Status
Protection and control status signals for all available protection functions
in device.
Metering
All metering values available in device. Primary and secondary values,
frequency and phasor diagram provided.
Inputs/Outputs
All input and output status provided. For contact inputs and contact
outputs as well as virtual input and virtual output signals.
Records
Only enabled in on line mode, retrieval of all the available records in
device. Snapshot events, control events, oscillography and fault reports.
STATUS
Operation bits
Up to 24 elements. OPERATION BIT XX is (0) when the configured time
out for the operation XX expires or when success conditions are met.
And it is (1) if operation XX is executed and interlocks are fulfilled.
Breaker
Breaker status (open, closed or undefined). The rest of the status signals
corresponding to the switchgear XX configured as breaker are in the
" Status>Switchgear Status>Switchgear XX " menu.
Protection Status of all the protection units in the device.
Control Elements Status of all the control units available in the device.
Protection Summary
This screen shows a complete list of all protection and control elements
in the relay, showing their status (enabled or not).
Snapshots events
summary
Summary of the snapshot events status (enabled or disabled) for
protection, control, inputs and outputs boards and switchgear.
ModBus User Map
Up to 256 elements. Value in SIGNED INT 16 BIT format of the reading
for the selected address configured in " Setpoint>Product
Setup>ModBus User Map "
Switchgear Status
Up to 16 blocks of switchgear status signals for the 16 configurable
devices. Status signals such as inputs for A and B contacts, status for A
and B, open and close status, error 00 and error 11, open init and close
init, fail to open and fail to close signals.
Calibration
Internal states for calibration. Factory calibration and calibration error
signals.
Flex Curves
Flex curve status for A, B, C and D user curves. (0) if it is not configured,
(1) if it is configured. To configure a flex curve go to " Setpoint>System
Setup>Flex Curves " menu.
System Info
This screen can monitor the system parameters and the internal status of
the Relay operative system. Not enabled by default, password required
Records Status
Information related to the different records stored in the Relay, such as:
Fault reports, control events, oscillography, data logger, demand, energy,
and breaker maintenance.
SNTP-IRIG_B & PTP
1588
Information related to synchronization via IRIG_B, SNTP or PTP1588.
Versions
Information related to the different firmware versions and hardware
revisions.