16
49-2000492 Rev. 0
Installation Instructions
D
ALIGNING THE MOUNTING PLATE
CAUTION
Wear gloves to protect against
sharp edges.
1. Draw a vertical line on the wall at the center of the
ƎZLGHVSDFH
2. Use the mounting plate as the template for the rear
wall. Place the mounting plate on the wall, making
sure that the tabs are touching the bottom of the
cabinet or the level line drawn in Step C for cabinets
with front overhang. Line up the notch and center line
on the mounting plate to the center line on the wall.
3. While holding the mounting plate with one hand,
draw circles on the wall at holes A, B, C, and D (see
illustration above/actual plate marked with arrows).
Four holes must be used for mounting.
NOTE:
Holes C and D are inside area E. If neither
C nor D is in a stud, find a stud somewhere in area
E and draw a fifth circle to line up with the stud. It is
important to use
at least one wood screw mounted
firmly in a stud
to support the weight of the unit.
Set the mounting plate aside.
WARNING
Risk of electric shock. Can cause
injury or death. Take care to not drill into electrical
wiring inside walls or cabinets.
4. Drill holes on the circles. If there is a stud, drill a
»ƎKROHIRUZRRGVFUHZV)RUKROHVWKDWGRQ¶WOLQH
XSZLWKDVWXGGULOOD»ƎKROHIRUWRJJOHEROWV
NOTE: DO NOT MOUNT THE PLATE AT THIS TIME.
1. PLACEMENT OF THE MOUNTING PLATE (Cont.)
Draw a
Vertical Line
on Wall from
Center of Top
Cabinet
Area E
Hole A
Hole B
Hole D
Notch
Hole C
30”
INSTALLATION INSTRUCTIONS
