14
49-2000492 Rev. 0
Installation Instructions
A
REMOVING THE KITCHEN HUB
FROM THE CARTON/REMOVING
THE MOUNTING PLATE
Remove the packaging
CAUTION
Wear gloves to protect against
sharp edges.
1. Open the box and fold back all four carton
flaps fully against the carton sides. Remove the
following items from the protective foam: charcoal
filters, cord plug, damper, and screws. Do not
remove the foam protecting the front of the unit.
2. Carefully roll the unit and carton over onto the top
side. The unit should be resting in the foam.
3. Pull the carton up to remove.
4. The mounting plate is attached to the back of
the unit. Remove the two screws holding it to
the back. The plate will be used as the rear wall
template and for mounting the unit to the wall.
5. Set the unit upright. Remove and properly discard
plastic bags and foam.
B
FINDING THE WALL STUDS
1. Find the studs, using one of the following methods:
A.
Stud finder
OR
B.
Use a hammer to tap lightly across the
mounting surface to find a solid sound. This will
indicate a stud location.
2. After locating the stud(s), find the center by probing
the wall with a small nail to find the edges of the
stud. Then place a mark halfway between the
edges. The center of any adjacent studs should be
ƎRUƎIURPWKLVPDUN
3. Draw a line down the center of the stud.
IMPORTANT:
The unit must be installed to at least
one wall stud.
1. PLACEMENT OF THE MOUNTING PLATE
Carton
Foam
Wall
Studs
Center
Screws
Mounting Plate
INSTALLATION INSTRUCTIONS
