49-2000492 Rev. 0
25
INST
ALLA
TION INSTRUCTIONS
C2
ATTACH THE MOUNTING PLATE
TO THE WALL (Cont.)
1. Remove the toggle wings from the bolts.
2. Insert the bolts into the mounting plate through the
holes designated to go into drywall and reattach the
WRJJOHZLQJVWR»ƎRQWRHDFKEROW
To use toggle bolts:
3. Place the mounting plate against the wall and insert
the toggle wings into the holes in the wall to mount
the plate.
NOTE:
Before tightening toggle bolts and wood
screw, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed flush
against the wall and that the plate is properly centered
under the cabinet.
CAUTION
Be careful to avoid pinching fingers
between the back of the mounting plate and the wall.
4. Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
Installation Instructions
C. OUTSIDE BACK EXHAUST
(Horizontal Duct)
INSTALLATION OVERVIEW
C1.
Prepare Rear Wall
C2.
Attach Mounting Plate to Wall
C3.
Prepare Top Cabinet
C4
. Adjust Blower Exhaust
C5.
Mount the Kitchen Hub
C6.
Finalize Installation
C1
PREPARING THE REAR WALL
FOR OUTSIDE BACK EXHAUST
You need to cut an opening in the rear wall for
outside exhaust.
• Read the instructions on the REAR WALL
TEMPLATE.
• Tape it to the rear wall, lining up with the holes
previously drilled for holes A and B in the mounting
plate.
• Cut the opening, following the instructions of the
REAR WALL TEMPLATE.
C2
ATTACH THE MOUNTING PLATE
TO THE WALL
Attach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach the plate to
a wall stud.
Wall
Mounting
Plate
Spacing for Toggles More
Than Wall Thickness
Toggle
Bolt
Toggle Wings
Bolt
End
