Operating the REMOTE CONTROL (RC) BURNER.
Operating the stove WITH the Remote Control Handset.
Lighting the burner.
If closed
,
open the isolating ‘T’ connector valve.
Turn the ‘manual’ knob to the ON, full counterclockwise
position.
Simultaneously press and hold the ‘OFF’ and
(large flame) buttons until a short
acoustic signal confirms the start sequence has begun; release buttons. Continuing
signals confirms the ignition is in progress. There will be a slight delay and several
sparks should be see
n between the electrode and pilot tip. Once pilot ignition is
confirmed there is main gas flow.
When pilot ignition is confirmed, the motor turns automatically to maximum flame
height.
Adjusting flame height.
When the burner is operating press the
(large flame) button to increase the
flame height and press the (small flame) to decrease the flame height. For fine
adjustment press the
/ button for approximately two seconds until an acoustic
signal is given, then release the button.
Please note:
-
The flames on the N.G. appliance will appear predominantly blue. The flames
on the L.P.G. appliance will appear predominantly yellow.
-
The appliance will operate to its maximum potential if the flue is primed
during the first 20 – 30 minutes of operation. To do this, simply set the control
knob to its ‘HIGH’ setting. This will also burn off any dust deposits that may
have formed during the appliance being switched off.
Adjusting to pilot only setting.
When the burner is operating press and hold the (small flame) until the burner
flame extinguishes. To turn the main burner on again simply press and hold the
(large flame) button.
Page 28
©
GDC Group Ltd. 2015
OWNER GUIDE
