5.
Locate the burner assembly
inside the stove body as in figure 8
(The outer body of the stove is not
shown for clarity). Secure using the
six No.4 x 10mm screws supplied
6.2 Gas connection.
-
A nut and olive are provided for an 8mm pipe inlet connection to the elbow at the
bottom front of the appliance. The elbow can be rotated to allow a connection from
any direction. The elbow includes a valve for isolating the gas supply.
-
The supply pipe must be rigid material. Flexible pipe must not be used.
Note: Prior to connecting the gas supply it is advisable to blow out the gas
supply so that any dirt which may be present in the pipe is cleared and cannot
enter the gas valve or pilot burner and so cause a blockage.
- Connect the supply line to the appliance.
- Turn on the gas supply and pressure check the installation pipework for gas
soundness. In the United Kingdom (GB) check in accordance with the current edition
of BS 6891. In the Republic of Ireland check in accordance with the current edition of
IS 813 “Domestic Gas Installations.”
7. FITTING THE CERAMIC FUEL EFFECT
The installer and owner guide for the ceramic fuel effect is supplied with the ceramic
fuel effect. It is important that the installer guide for the ceramic fuel effect be placed
inside or attached to this guide and handed to the customer following completion of
the ‘Final review and servicing’ section.
Page 14
©
GDC Group Ltd. 2015
INSTALLER GUIDE
Figure 8.
