GCC Technologies LaserPro C180II, Руководство пользователя

Страница: 48 / 141

48 232001840G(08)
LED INDICATOR LIGHTS
Three indicator lights on the LaserPro C180II’s control panel are part of the system’s safety interlock
system.
• DOOR - The door light will illuminate when either the top lid or external pass through doors on the
LaserPro C180II are open or improperly closed.
• POWER - The power light will illuminate when the LaserPro C180II is powered on.
• LASER - The laser light will illuminate when the laser is active and in operation.
WARNING
• DO NOT attempt to remove or modify any component of the safety interlock system.
• If at any time, any of the access doors are open and the “laser” LED is illuminated,
IMMEDIATELY unplugs the laser system and contact GCC technical support for service
instructions.
• DO NOT operate the laser system if any component of the safety system is malfunctioning.
NOTE
There is an 8 seconds warm up period after the door LED is triggered for systems
equipped with Synrad laser tubes. i.e. opening the top lid or the external pass through
doors of the machine. Operator must wait for 8 seconds before the laser tube can
begin to work. A 40 seconds laser warm up period is required after the machine is
turned on. A warning will be displayed if the user tries to run a job during the 40
seconds warm up time.
Directional and Selection Buttons
Function (F1 / F2 / F3 / F4) – Four function buttons allow you to select various functions which will
change depending on what section of the menu you are in. Each function button’s corresponding
task will be displayed right above its respective button on the LCD display screen. Please note that
in certain menus, not every function button will always be mapped to a corresponding action. In
these situations, that particular button will not have a function.
Directional (
U
/
V
/
Y
/
Z
)
ȸ
Four directional buttons allow you to navigate the selection cursor
through the control panel menu and adjust the value of specific settings. In general, the Y / Z
directional buttons cycle through the various selections, while the U / V directional buttons adjust
the value of that particular selection.
Enter – Confirms the current selection.
Start / Stop – Allows you to start or stop engraving jobs, once those jobs have been successfully
loaded onto the system.
Delete – Provides quick access to delete the current job.
Pause – Pauses the current engraving process. Press again to resume the current process.
Auto Focus – After you have positioned your material and moved the laser carriage head to the
area you want to engrave, press this button and the system will automatically adjust the optimal
vertical focal distance for the laser.
Manual Focus ( S / T )
ȸ
To manually adjust the vertical focal distance between the laser head