GBG 5 Liters, Руководство по эксплуатации

Страница: 41 / 83

- 7_GB - SL3000108 Ed.03 - 10-06
important note: do not lift the machine by holding onto the product
dispenser (tap), drainage tube or water level tube: any damage cau-
sed to the machine by failure to abide by this instruction shall not
be covered by the warranty.
After positioning the packing container in the vicinity of the installation site, pro-
ceed as follows:
1. Open the front part of the packing container;
2. lift the machine out of the container;
3. then position it on the prepared site.
before the machine is operated the first time, its components must
be thoroughly cleaned; for further details see the relevant section
herein.
5.3. Disposal of packing materials
After opening the box, make sure to separate the packing materials according
to type and dispose of them in accordance with the current regulations in the
user’s country.
We recommend keeping the box for future conveyance or transport
5.4. Electrical connection
This job may be performed only by specialized technical per-
sonnel.
Before plugging in the machine, make sure that the on/off switch is on “0”.
The Purchaser is responsible for making the electrical connection.
The machine must be connected to the electricity mains by means of the plug
fi tted on the power cord. Be sure to comply with:
• the technical regulations and standards in force at the time of installation;
• the data shown on the rating plate on the side of the machine.
warning: the electric outlet must be situated in a place easily
within reach of the user, so that no effort is required in order
to disconnect the machine from the power supply when neces-
sary.
if the power cord is damaged, you must have it replaced either by the
manufacturer or a specialized technician
it is forbidden:
• to use extension cords of any type;
• to replace the original plug;
• to use adaptors.
6. oPEraTioN
Before the machine may be started up for the fi rst time, specialized tech-
nical personnel must check that it functions properly.
6.1 Starting up
warning: never operate the machine without water in the boiler
as this would damage the heating element. a temperature sen-
sor will in any case cut out power to the heating element if there
is no water in the boiler. To restore the machine to normal operation press
the pushbutton underneath the base.
Warning: during bowl and/or boiler fi lling operations the machi-
ne must be unplugged.
To start up the machine carry out the following steps:
• Take off the lid;
Fig.6
Fig.7
• Fill the boiler by introducing water into the water level tube until reaching the
“MAX” level indicated on the tube itself;
Make sure the water level never falls below the “MIN” level.
Warning: fi ll the boiler with demineralized water only. Fill or top
up only when the machine is at room temperature.
Do not introduce water containing carbon dioxide and/or che-
mical additives into the boiler.