Gateway NV-53, Руководство по обслуживанию

Страница: 127 / 168

www.gateway.com
121
Index of error messages
Error codes
Error messages
Error Codes Error Messages
006 Equipment Configuration Error
Causes:
1. CPU BIOS Update Code Mismatch
2. IDE Primary Channel Master Drive Error
(The causes are shown before “Equipment Configuration Error”)
010 Memory Error at xxxx:xxxx:xxxxh (R:xxxxh, W:xxxxh)
070 Real Time Clock Error
071 CMOS Battery Bad
072 CMOS Checksum Error
110 System is disabled. An incorrect password was entered.
<No error code> Battery is critically low. In this situation BIOS issues four short beeps, then shuts the system
down. No message is displayed.
<No error code> Temperature is critically high. In this situation BIOS shuts the system down. No message is
displayed.
Error Messages FRU/Action Sequence
Failure Fixed Disk
n
Reconnect the hard disk drive connector.
n
Run “Load Setup Defaults” using the BIOS Setup Utility, then reboot
the notebook.
n
Test or replace the hard disk drive.
n
Test or replace the system board.
Stuck Key See “Testing the keyboard or auxiliary input device” on page 117 .
Keyboard error See “Testing the keyboard or auxiliary input device” on page 117 .
Keyboard Controller Failed See “Testing the keyboard or auxiliary input device” on page 117 .
Keyboard locked - Unlock key switch Unlock the external keyboard.
Monitor type does not match CMOS - Run Setup Run “Load Setup Defaults” using the BIOS Setup Utility, then reboot the
notebook.
Shadow RAM Failed at offset: nnnn
n
Test or replace the BIOS ROM.
n
Test or replace the system board.
System RAM Failed at offset: nnnn
n
Test or replace the SO-DIMM.
n
Test or replace the system board.
Extended RAM Failed at offset: nnnn
n
Test or replace the SO-DIMM.
n
Test or replace the system board.
System battery is dead - Replace and run Setup Test or replace the CMOS battery, run the BIOS Setup Utility to
reconfigure system time, then reboot the system.
System CMOS checksum bad - Default
configuration used Test or replace the CMOS battery, run the BIOS Setup Utility to
reconfigure system time, then reboot the system.