Gateway 8400, Системное руководство

Страница: 64 / 146

Adding an expansion card
55
To add a half-length expansion card:
1
Observe the safety and ESD precautions in “Preventing static electricity
discharge” on page 15.
2
Turn off the system and disconnect the power cord(s), modem cord (if
installed) and all other external peripheral devices.
3
Remove the back access panel. (See “Removing the side panels” on
page 18.)
4
Remove the memory module retention bracket and the foam cover on
the lower electronics bay. (Do not remove the plastic air baffle attached
to the foam cover.)
5
Locate an available half-length slot.
6
Remove the screw securing the slot cover in place, then remove the cover.
7
Set any jumpers on the card to the appropriate settings (refer to your card
documentation for jumper settings).
8
Holding the card by its top edges, firmly press the card into the selected
expansion slot on the system board.
9
Using the screw you removed previously, secure the card into place.
05895.book Page 55 Thursday, May 11, 2000 1:11 PM