Gateway 8400, Системное руководство

Страница: 44 / 146

Replacing or adding drives
35
To install a 3.5-inch device in a 5.25-inch drive bay:
1
Observe the safety and ESD precautions in “Preventing static electricity
discharge” on page 15. Also see the cabling information in “Drive cabling
considerations” on page 27.
2
Open the computer door.
3
Remove the right side access panels (see “Removing the side panels” on
page 18).
4
Using the hole in the front of the metal EMI shield, pull out on the left
side of the shield to disengage it from the chassis (see “To install a
5.25-inch device” for illustration). Remove and save the shield.
5
Open the drive bay (see “Opening the chassis bays” on page 20) to gain
access to the back of the 5.25-inch drive bay.
6
Remove the drive from its protective wrapper, and place it on an antistatic
surface.
7 Set any jumpers or switches on the drive according to the drive
manufacturer’s instructions.
Important System EMI integrity and cooling are both protected by
having drives installed in the bays or filler panels and EMI
shields covering the bays. When you install a drive, save
the panel and shield to reinstall in case you should later
remove the drive and not reinstall one in the same bay.
05895.book Page 35 Thursday, May 11, 2000 1:11 PM