54
Replacing and Adding System Components
7
Set any jumpers on the card to the appropriate settings (refer to your card
documentation for jumper settings).
8
Holding the card by its top edges, firmly press the card into the selected
expansion slot on the system board.
9
From the back of the system, press the plastic card retainer in to hold
the card in place.
10
If the card is a full-length card with a plastic stabilizer, close the plastic
rear retention latch to secure the other end of the card in place.
11
Replace the back access panel.
12
Reconnect the power cord(s), modem cord (if installed), and all other
external peripheral devices.
13
Restart the system and install drivers as necessary.
You may need to reconfigure your system after installing some expansion
cards. You may also need to install software that came with the card. Check
the card documentation for additional information.
1
2
3
05895.book Page 54 Thursday, May 11, 2000 1:11 PM
Содержание 8400
