Gates GC96, Руководство оператора

Страница: 6 / 24

9/5/2007 5
3. Install power cord plug.
The crimper is equipped with an
I
nverter which allows the
machine to run from any 20amp 220-250VAC outlet. The crimper
also is equipped with a NEMA L6-20 power cord plug.
▲
WARNING:
•
Have a qualified electrician install the correct NEMA L6-20 outlet for your
power supply.
•
Incorrect electrical connection can cause damage to component or an
electrical hazard for personnel.
NOTE: Incorrect power cord installation will void your equipment warranty.
Turn power switch on. It will take several seconds (approx. 120 sec.) for the TOUCH
SCREEN control panel to boot up and show the CRIMP SCREEN. Once the CRIMP
SCREEN is showing Press the CRIMP button to check the pump motor operates. If
motor is not operating
contact your local Gates supplier.
4. Install foot pedal.
This crimper can also be activated by using a foot pedal. The foot pedal
has an auto retract feature and is activated after the head gets to crimp
diameter.
The protective metal case surrounding the pedal will avoid
accidental activation. Install foot pedal by plugging it into the lower right
side control panel.
5. Position control panel to a comfortable working position.
The control panel can be rotated to a position that is more accessible depending on
where the operator is working. Loosening the locking handle located to the left of the
control panel will allow panel to pivot approximately 90 degrees left or right.
6. Lubricate die shoe grease fittings.
Press and hold top CRIMP button and cycle head to fully closed position or until grease
fittings are exposed.