Gastrodomus PMA25, Руководство по эксплуатации и техническому обслуживанию

Страница: 24 / 58

23
Now shut the cover and put the selector in
the position ( Fig. 4A ).
Push the start button ( Fig. 4B ).
Add the liquid part pouring it slowly but
quickly through the small hole in the cover.
At the end of the kneading operation, which
should take around 10 minutes, make sure
the product has the right thickness and
should look like coffee beans (check throu-
gh the small holes of the cover).
Turn the machine off by switching the selec-
tor to “0” ( Fig. 4C ), or push the Stop button
(
Fig. 4E
).
3.3 INSTALLATION OF THE DRAWPLATE
AND START-UP OF PRODUCTION
Make sure the machine is switched
off.
Withdraw the drawplate ( Fig. 5A ) reque-
sted by the container filled with water where
it was put after its last use.
Thoroughly rinse with plenty of running
warm water in order to have the piece at the
right temperature (see chapter 6 CLEANING
page 25). Dry it with a soft cloth. Unscrew
D
A
C
B
E
Fig. 4 – PMA25 Control Panel
C
A
B
Fig. 5
A
the blocking ring nuts (
Fig. 5B
B
and
6A
)
B
and carefully clean the internal part inclu-
ding the edging.
Take the plastic cap off (
Fig. 5C
and
6B
).
Disassemble the drawplate ( Fig.7A
A
).
Fig. 6
Screw in the ring nuts by hand and verify
that all the pieces are in their places and
that they are aligned along the axle.
In order to start production, position the
selector on the position ( Fig. 4D ) and
push the start button ( Fig. 4B ).
The initial product coming out of the machi-
ne has an unacceptable look; this is the rea-
son why it has to be disposed.
After a short time (a couple of minutes) the
product coming out is acceptable, the
colour goes from whitish to yellow and it has
a greater thickness.
The cut of the pasta at the desired length
can be made by hand or by knife.
In the first case it is usually long length
A
Fig. 7