10.11.
Inspection mode use
This Mode is used for the inspector to identify the Sensor status and Fault details without
affecting the equipment operated in emergency. Only authorized personnel are allowed to use
this Mode.
Press and hold the "↓" Switch for at least 3 seconds while Means
value display gas concentrations in the display. Press and hold the
"↓" Switch for at least 3 seconds to exit again.
Entering Inspection Mode, '#' mark will flash at the first place in
the second row.
You can enter M/L item from Maintenance Mode to set Output
value.
10.12.
Data initialization
Only authorized personnel are allowed to conduct this Mode because it will initialize all the
values to the data set in the factory before shipping.
Turn the power ON while holding "FUNC" Key and "UP" Key.
When "ALL - INIT" is displayed on the Display window, select "YES" to
carry out the data initialization.
10.13.
Correction data initialization
Only authorized personnel is allowed to conduct the initialization because this Mode initializes
to the value of Calibration data set in the factory before shipping. This Mode is used for the
inspector to initialize only the Calibration value among setting values.
Turn the power ON while holding "FUNC" Key and "UP" Key.
When "CAL - INIT" is displayed on the Display window, select "YES" to
carry out the normal initialization of Calibration data.
CAL
CAL
CAL
CAL ---- INIT
INIT
INIT
INIT
[ YES ]
[ YES ]
[ YES ]
[ YES ]
ALL
ALL
ALL
ALL ---- INIT
INIT
INIT
INIT
[ YES ]
[ YES ]
[ YES ]
[ YES ]
[ %L
[ %L
[ %L
[ %LEL]
EL]
EL]
EL]
# 0 ]
# 0 ]
# 0 ]
# 0 ]
