GasTech GTD2000-Tx, Руководство оператора

Страница: 27 / 38

10.7. Maintenance Mode setting
※
Only authorized personnel are allowed to perform these settings.
Touching "FUNC" switch with Magnet-bar for 2 seconds in Measuring

Condition will enter the Password mode.
Touch the "FUNC" switch after setting password using "↑" or "↓" switch.
Select “Maintenance MODE” by touching "↑" or "↓" switch.
Touching “FUNC” switch when “MAINTEN. MODE” is displayed will enter
Maintenance setting Mode.
Measuring Condition will return on touching “RESET” switch.
It sets the Cross sensitivity (0.1 ~ 5.0) of the sensor.
Value setting is done by touching "↑" Switch or "↓" Switch by 0.01 units.
Touching "FUNC" Switch will enter the next item.
It sets the Zero region sensitivity of the sensor.
Value setting is done by touching "↑" Switch or "↓" Switch by 1 unit.
The gas value less than corresponding setting is considered as 0; the
setting is possible up to 10% of the High Scale.
Touching "FUNC" Switch will enter the next item.
It sets the Measuring Value delay depending on the set time.
It sets whether to use Auto Zero function.
Touching the “↑ “or “↓ “Switch toggles” ON "and" OFF ". Auto zero
function operates if it is ON (default is ON).
If Auto Zero is ON, automatic Zero Calibration is performed when the
value is maintained over 10 minutes less than 0.5% of variation within the
values from Auto Zero minimum to 5% of the High Scale.
It sets the minimum value of Auto Zero.
This Mode sets the percentage of High Scale in the range of 1.0%~4.0%.
Touching "FUNC" Switch will enter the next item.
It sets whether to use Base Zero function.
Touching the “↑ “or “↓ “Switch toggles” ON "and" OFF ". Base zero
function operates if it is ON (default is ON).
If Base Zero is ON, automatic Zero Calibration is performed when the
value is maintained over 10 minutes from 0.02% of the High Scale to Base
Zero maximum.
Touching "FUNC" Switch will enter the next item.
BASE BASE BASE BASE----ZZZZ
[ ON]
[ ON] [ ON]
[ ON]
AZ MIN. AZ MIN. AZ MIN. AZ MIN.
[2.0]%F [2.0]%F [2.0]%F [2.0]%F
AUTO AUTO AUTO AUTO----ZZZZ
[ ON] [ ON] [ ON] [ ON]
ZZZZ----SKIP SKIP SKIP SKIP
[ 0.0]%F [ 0.0]%F [ 0.0]%F [ 0.0]%F
CRO CRO CRO CRO----SEN. SEN. SEN. SEN.
[1.00]xG
[1.00]xG [1.00]xG
[1.00]xG
MAINTEN. MAINTEN. MAINTEN. MAINTEN.
MODE MODE MODE MODE
PASSWORD PASSWORD PASSWORD PASSWORD
[**]
[**] [**]
[**]
ODT
ODT ODT
ODT
[ 0]SEC [ 0]SEC [ 0]SEC [ 0]SEC