Gasboy CFN Series, Руководство для стартапов, Страница: 91 / 119

Pump/Dispenser Automatic Tests
03/07/03 11-5
5. After a few gallons, hang the nozzle back on the pump. Verify that the correct EID and VM
data have been recorded.
6. Repeat for all hose outlets.
READER ENTRIES AND FUEL POINT
If your system was ordered with the reader entry option, you must enter data at the card reader
with every Fuel Point transaction. This entered data is combined with the data already
programmed into the vehicle module.
1. Insert the wired-hose into the vehicle’s fill pipe, or, park the vehicle over the ground loop,
whichever is applicable.
2. Go to the card reader that is assigned to the Fuel Point controlling this hose. The card reader
is assigned to a Fuel Point reader in the FUELPT.BIN configuration program.
3. The reader will be scrolling broadcast messages, or a SLIDE CARD message. On the
keypad, press the pump number that you are using, followed by the ENTER key. The display
now prompts you to enter certain data. Follow the prompts until finished.
4. The pump should turn on when all entries have been successfully entered.
OBTAINING A RECEIPT FOR FUEL POINT TRANSACTIONS
If using an Island Card Reader:
1. Once the transaction has been completed, go to the Island Card Reader. The reader will be
scrolling broadcast messages, or a SLIDE CARD message. Select the pump number you
just used, followed by the ENTER key.
2. There is no further prompting for the receipt. The receipt will print for the last transaction that
occurred at that pump within the last 20 minutes. Since only the last transaction at that pump
is available as a receipt, you must get your receipt before allowing another transaction to
complete at that pump.
If using an Electronic Dispenser with a built-in printer:
1. After the transaction has completed, the receipt will be printed automatically, or the display
may prompt for the receipt, depending on the configuration in SYS_PAR.BIN .
MASTER/SATELLITE DISPENSERS WITH FUEL POINT
The design of the Fuel Point system allows a nozzle ring on the master dispenser only. That
means the master nozzle must always be inserted in the truck’s fill pipe with the tank ring in order
for the satellite dispenser to operate. If the truck must be able to pull into the fuel lane from either
direction, then you may add a tank ring to both fill pipes.