GAS GAS Enduro 2T 250 2018, Руководство пользователя

Страница: 33 / 77

Owner's Manual
-33-
When you have to store your motorcycle for a period of time you should:
•
Thoroughly clean the motorcycle.
• start the engine for about 5 minutes to warm up the transmission oil and
then empty it (see maintenance).
• put in new transmission oil.
• Empty the fuel tank (if left for a long time the petrol deteriorates).
• Lubricate the chain and all cables.
• put oil on all unpainted metal surfaces to prevent rust, avoiding getting oil on
the brakes and rubber parts.
• place the motorcycle in such a way that the two wheels do not touch the
ground (if this is not possible put cardboard under the wheels).
• cover the motorcycle to protect it from dust and dirt.
To put it into operation after storage:
•
Remove the plastic bag from the exhaust pipe.
• Tighten the spark plug.
• fill up the fuel tank.
• check the points in the section "daily inspection before riding".
• general lubrication.
Storage
OBD Operation
The oBd (on Board diagnostic) system incorporates a miL indicator light to
indicate a malfunction.
When the motorcycle is started, the miL (malfunction indicator Light) light is on.
if there is no error, the miL turns off after 5 seconds.
if the oBd system detects an error, the miL light stays on permanently.
it will turn off if it is started 3 consecutive times exceeding 2,000 rpm, if no error
is detected.