GAS GAS Enduro 2T 250 2018, Руководство пользователя

Страница: 44 / 77

Owner's Manual
-44-
change coolant
it must be changed periodically for a long engine life.
1. Wait for the engine to cool completely.
2. put the motorcycle in the use position.
3. Remove the radiator cap.
4. place a container under the drain screw (2) which is located on the underside
of the water pump cover. drain the radiator and engine fluid by unscrewing.
5. fill the radiator to the rim of the cap and fit the radiator cap.
6. check the cooling system for leaks.
7. start the engine, warm it up and finally stop it.
8. check the coolant level when the engine cools down. add liquid to the
stopper if necessary.
DanGer
To avoid burns do not remove the radiator cap or try to change the liquid when
the engine is still hot. Wait until it cools down.
DanGer
if liquid falls on the tires it makes them more slippery and can cause an accident.
immediately clean any liquid that may fall into the chassis, engine or wheels.
inspect the old liquid. White spots on the liquid will mean that the aluminium
parts of the cooling system are corroded. if the liquid is brown it is because the steel
or iron parts of the system are rusted. in both cases clean the system.
WarninG
Tighten the drain screw on the water pump to 9 nm. Replace the gaskets with
new ones.
check for any damage, loss or lack of seals in the cooling system.
cold countries should adjust the antifreeze capacity to their minimum temperature
with a margin of -5ºc.
Maintenance
2