Garmin GNS 530W, Руководство и справочник пилота

Страница: 205 / 230

12 - MESSAGES
ABBREVIATIONS &
NAV TERMS
195
Near airspace — less than 2 nm — Your GPS-calculated
position is within 2 nautical miles of a special use airspace
boundary, but you are not projected to enter the airspace.
This message is automatically disabled within 30 nautical
miles of an arrival airport, when an approach is loaded.
No altitude input is being received — No altitude data
is being received from RS-232 (Serializer: Icarus, Rosetta or
Shadin) or grey code inputs. If the problem persists, contact
your Garmin dealer and check the installation and installa-
tion settings.
No basemap data available — The 500W-series unit
has detected a failure in the built-in basemap (land data)
memory. Land data does not appear on the Map Page.
Other unit functions continue to work normally, however
the 500W-series unit should be taken to your Garmin
dealer for service at your earliest convenience.
Not receiving input data on 429 Channel #1 or #2
—
No data has been received on the ARINC 429 channel
#1 connection for a period exceeding five seconds. If the
problem persists, the installation should be checked by your
Garmin dealer.
Not receiving input data on 232 Channel #(1 through
5) —
No data has been received on one (or more) of the
RS-232 channel connections for a period exceeding ten
seconds. If the problem persists, the installation should be
checked by your Garmin dealer.
Not receiving traffic data — No traffic data is being
received. If the problem persists, the installation should be
checked by your Garmin dealer.
OBS key stuck — The OBS key is stuck in the enabled
(or pressed) state. Try pressing the OBS key again to cycle
its operation. If the message persists, contact your Garmin
dealer for assistance.
OBS not available — The OBS mode could not be
activated, because 1) no destination waypoint has been
selected, or 2) the GPS receiver cannot currently determine
its position.
Obstacle database integrity error — The 500W-
series unit has detected a problem with a database on the
TAWS/Terrain data card. The data is not usable and the card
should be returned to your Garmin dealer for service.
RAIM position warning — Although sufficient GPS
satellite coverage may exist, Receiver Autonomous Integrity
Monitoring (RAIM) has determined the information from
one or more GPS satellites may be in error. The resulting
GPS position may be in error beyond the limits allowed
for your current phase of flight. Cross-check your position
with an alternate navigation source. If the warning occurs
during a final approach segment (FAF to MAP), execute the
published missed approach.
Scheduler message [1-9]— [user entered text] — The
user-entered scheduler message time has expired, and the
scheduler message is displayed.
Searching the sky — The 500W-series unit is searching the
sky for GPS satellites.
Select appropriate frequency for approach — You
are inbound and within 3 nautical miles of the FAF; and
the active VLOC frequency does not match the published
frequency for the approach. Tune the standby VLOC
frequency to the proper frequency and press the
VLOC
flip-flop key to “activate” the frequency.
Select VLOC on CDI for approach — ( GNS 530W only)
You are inbound and within 3 nautical miles of the FAF;
and the active approach is not a GPS-approved approach.
Verify that the VLOC receiver is tuned to the proper fre-
quency and press the
CDI key to display “VLOC” (directly
above the CDI key).
Set course to [###]° — The course select for the external
CDI (or HSI) should be set to the specified course. The mes-
sage only occurs when the current selected course is greater
than 10° different from the desired track.