background image

Install

VT-X5

The USFT VT-X5 Install Guide

USFleetTracking

Plug the two antenna cables and wiring harness into the device.

Place the antenna under the dash above the instrument cluster (reference Image A). The adhesive side of the 
antenna should be facing the sky.

A good placement of the device will yield a minimum of 7 
satellites. The device will not transmit data location with 
less than 4 satellites in view.

Run the antenna cables along the side of the dash at 
the door hinge and place the VT-X5 under the dash. For 
best results, use a zip-tie to secure the device to ensure 
it doesn’t fall from beneath the dash.

Our device transmits once every 30 minutes if sitting 
still, or once every 5 or 10 seconds (depending on your 
rate plan) when the vehicle is moving faster than 4 mph. 

Driving the vehicle around the block will assist in its first 

data transmission.

The best location has a full view of the sky through the front windshield (reference Image A.) Make sure the 
device is kept free from direct exposure to the elements (sun, heat, rain, moisture).

When installed inside a building, your unit may not receive a GPS signal or cellular signal. GPS signals WILL 

penetrate glass, plastic, foam, fiberglass, and wood. GPS signals will NOT penetrate metal.

Step 1 > Device Placement

Thank you for purchasing your new GPS vehicle tracking system!

Installation of your new GPS tracking device couldn’t be easier. 

Just follow these simple steps.

405.726.9900  |  2912 NW 156th Street  |  Edmond, Oklahoma  73013  |  

usft.com

Poor location
Ideal location

Image A

Please verify that your device is activated prior to installation. When 
activating a unit, refer to the SN# on the side of the device (see Image B).

The VT-X5 requires a standard 3-wire installation to operate effectively. 
Please familiarize yourself with the 3 wires required for functionality as well 
as the optional wires associated with added available features. The wire 
colors and functions are on the back side of this installation guide.

Step 2 > Wiring and Installation

Image B

NOTE: 

Do not cut wiring harness to shorten length of cable as this will void warranty.

Отзывы: