Garmin Approach G5 - GPS-Enabled Golf Handheld, Руководство пользователя

Страница: 57 / 168

Garmin G5 User's Manual 190-02072-00 Rev. B
45
Installation Manual
Installation Manual
Pilot's Guide
Index
1.7.4.3.2 o
n
G
round
i
nitiaL
C
heCkout
NOTE: The following post installation checkout must be followed after every
completed installation. These steps should be followed when using a Garmin
mounting kit or non-Garmin mounting parts to install the GSA 28.
After mounting the GSA 28, please complete the following steps prior to completing
the first flight with the GSA 28.
1) Verify that the flight controls can move from stop to stop without binding
or interference. Check that the GSA 28 output mechanism and added
linkage do not come in contact with any part of the airframe while traveling
through its full range of motion.
2)
Verify that the travel of the flight controls is being limited by the airplane’s
primary stops and not the secondary stops provided by the GSA 28 stop
bracket.
3)
Ensure the structural integrity of the mounting bracket is adequate for the
application and well secured to the airframe. Bracket deflection caused by
normal servo loading and aircraft acceleration/vibration should be minimal.
Also verify there are no cracks or sharp inside corners that could lead to
fatigue failures.
4)
Verify the fasteners used to mount the servo to the airframe are installed
and have been tightened.
5)
Make sure the AP DISC wire is correctly wired and tested.
6) If powering the servo through a “pullable” circuit breaker (recommended),
ensure the circuit breaker is both accessible and easily identifiable to the
pilot.
7)
Repeat steps 1-6 for all GSA 28 servos in the aircraft.