Part # 138683 (01/08)
Page 11
POWER FAILURE NOTE: In the event of a power failure, no
attempt should be made to operate this oven. This oven is
gas operated but has electrical features, motor and door
switches.
A wiring diagram is attached to the rear of this unit and a
copy is included in this manual for your use.
Lighting Instructions
PILOT
IGNITOR
BUTTON
REST
BUTTON
ON SAFETY
1. Using the access through the louver panel hold the reset
button (RED) located on the oven safety valve. (See prior)
2. Using the access hole located below the louver in the
panel, push the RED IGNITOR BUTTON continuously until
the oven pilot ignites. (See prior)
3. If the pilot does not stay lit after you release the reset
button, wait 5 minutes and repeat Step 2 and hold the
reset button approximately 60 seconds.
Start Up
1. Activate the power switch to cook position.
2. Turn oven valve on.
3. Turn thermostat to desired setting.
Cool Down
1. Turn thermostat and oven valve off.
2. Open
door.
3. Activate power to the cool down position.
OPERATING INSTRUCTIONS Continued
The motor on your range convection oven is maintenance
free since it is constructed with self-lubricating sealed ball
bearings. It is designed to provide durable service when
treated with ordinary care. We have a few suggestions to
follow on the care of your motor.
A. When the motor is operating, it cools itself internally by
air entering the rear of the motor case, provided proper
clearance has been allowed.
B. Since the blower wheel is in the oven cavity it is at the
same temperature as the oven. If the motor is stopped
while the oven is hot, the heat from the blower wheel is
conducted down the shaft and into the armature of the
motor. This action could shorten motor life.
C. We recommend, at the end of the bake or roasting
period, when the oven will be idle for any period of time
or before shutting down completely, that the doors
be left open, and by use of the cool-down position on
the fan switch, the fan continues to run for at least 20
minutes. The “FAN” should never be turned “OFF” when
the oven it “HOT”.
Starfire Sentry Ranges
General Notes
NOTE: Models with suffix “E” are equipped with an electric
spark ignition module for pilot burner ignition.
WARNING: If the pilot is extinguished either intentionally
or accidentally, no attempt should be made to relight for at
least five, (5) minutes.
Open Type Hot Plate
All burners are equally rated, and may be used for either
fast boiling or simmering. The pan supports will safely
accommodate pans from 5”, (125mm), in diameter. It is,
however recommended that pans larger than 12 “, (300mm),
be placed only on the rear burners.
NOTE: For maximum efficiency and stability, use flat bottom
utensils and center them over the burner head.
Lighting
(Models equipped with flame supervision devices):
1. Push in the valve knob, and turn it counter clockwise to
the ignition position.
2. While holding the valve knob fully in, light the pilot
burner with a match.
