Gardner Denver VST55-90B, Руководство по эксплуатации и обслуживанию

Страница: 52 / 84

13-17-618 Page 51
5-9
Oil Coalescing Element Service
–
Use the following procedures to replace or inspect the element:
1.
Be sure the unit is completely off and that oil pressure is depressurized.
2.
Disconnect, lockout and tagout power supply to the compressor package.
3.
Remove screws holding the top plate to the oil separator vessel and lift the top plate away.
4.
Lift the element from the reservoir.
5.
Inspect and/or replace the element if necessary - shine a light inside the element to reveal areas of
heavy dirt, varnish deposits or breaks (ruptures) in its media.
6.
Inspect the (sealing) o-ring for damage. Before installing new or old element, apply (heavy) grease
to sealing o-ring. Oil may be wiped off by the chamfer and the o-ring could be damaged.
7.
Wipe the cover seal o-ring clean and inspect for damage. Replace if necessary.
8.
Lower element into reservoir and center on the chamfer. Press element down into reservoir. Do not
use excessive force as element damage may occur while centering it.
9.
Carefully place cover and o-ring seal on the reservoir flange. Check that the adjustable spacer (e.g.,
pipe segment threaded under cover) does not contact the top of the element and prevent the cover
from seating flush against the matching separator-housing flange. Install and tighten all cap screws.
10. After compressor is started and pressurized, inspect cover-to-reservoir joint for leaks.