AFTER SALES SUPPORT
27
1300 855 831
MODEL: MFH3300-4P PRODUCT CODE: 47629 02/2017
AUS
MFH3300-4P
Working instructions/Cleaning/Maintenance
Avoid kickback
The best protection is to avoid situations that lead to setbacks.
1.
Keep the position of the upper guide rail always in mind.
2.
Leave this place never come into contact with an object. Cut anything with it. Be
especially careful near wire fences and cutting small, hard knots, in which the
chain can easily pinch.
3.
Cut only one branch at a time.
Withdrawal
The withdrawal occurs when the chain on the underside of the bar suddenly gets
stuck because it is jammed or encounters a foreign object in the wood. The chain
then pulls the saw forward. The withdrawal often happens when the chain is not
running at full speed when in contact with the wood.
Avoid withdrawal
Be aware of the forces and situations that can lead to jamming of the chain on the
underside of the bar.
Only start cutting when the chain is running at full speed.
Recoil
The recoil occurs when the chain on the topside of bar suddenly gets stuck because
it is jammed or encounters a foreign object in the wood. The chain can press the
saw against the operator. Recoil often happen if the topside is used for cutting.
Avoid recoil
Be aware of the forces and situations that can lead to jamming of the chain on top of
rail.
Do not cut more than one branch at a time.
Do not tilt the rail to the side when you pull the blade out of a cutting gap, since the
chain could get caught otherwise.
X. CLEANING
•
Keep all safety devices, air vents and the motor housing free of dirt and dust
as far as possible. Wipe the equipment with a clean cloth or blow it with com-
pressed air at low pressure.
•
We recommend that you clean the device immediately each time you have fin
-
ished using it.
•
Clean the equipment regularly with a moist cloth and some soft soap. Do not
use cleaning agents or solvents - these could attack the plastic parts of the
equipment. Ensure that no water can seep into the device.
