AFTER SALES SUPPORT
19
1300 855 831
MODEL: MFH3300-4P PRODUCT CODE: 47629 02/2017
AUS
MFH3300-4P
Before starting the equipment/ Attachment
Never use oil for 4-stroke engine or water cooled 2-stroke engine. It can cause
spark plug fouling, exhaust part blocking or piston ring sticking.
Mixed fuels, which have been left unused for a period of one month or more, may
clog the carburetor or result in the engine foiling to operate property. Put remaining
petrol into an airtight container and keep it in a dark and cool room.
2
Petrol mixing table
Mixing procedure: 40 parts petrol to 1 part oil
Example:
1 L Petrol : 0.025 L 2-stroke oil
5 L Petrol : 0.125 L 2-stroke oil
m
WARNING!
Take care of the emission of exhaust gases.
Always shut off engine before fueling. Never add fuel to a machine with a run-
ning or hot engine. Take care of fire!
Ensure that the hedge trimmer attachment is adequately greased. Check after
every 10 hours of use.
Ensure that the chain saw attachment is adequately greased. Check after every
10 hours of use.
VII. ATTACHMENT
ASSEMBLY
1.
Assemble the handle on the machine (Fig. 2-3)
•
Install the front handle as shown on the (Fig. 3).
•
Make sure that you align the pin with the hole. Tighten the screws only loose-
ly before you have the most comfortable working position set to the risers. The
front handle should be aligned as in (Fig. 2+3) shown, then tighten the screws.
2.
Mounting the shaft (Fig. 4)
•
Pull out the locking pin (a) and insert the lower part of the shaft (b) until the
locking pin engages. The locking pin (a) is in the right position when it is fully
seated in the bore.
•
Lastly, tighten the knob (c) securely.
3.
Assemble the protection shield (Fig. 5-7)
•
Fix the protection shield (17) at the brush cutter attachment (16) with 4 screws.
Use the screwdriver and wrench enclosed.
m
WARNING!
Use only original manufacturer‘s replacement parts, accessories
