AFTER SALES SUPPORT
23
1300 855 831
MODEL: MFH3300-4P PRODUCT CODE: 47629 02/2017
AUS
MFH3300-4P
Operation/ Working instructions
working condition. Never use a damaged, poorly adjusted or serviced or not
completely and securely assembled device.
Check before use!
•
Check the safe condition of the device:
•
Check the device for leaks.
•
Check the device for visual defects.
•
Check that all parts of the device have been securely fitted.
•
Check that all safety devices are in proper condition.
Start (Fig. 19-23)
Once the machine has been set up properly, start the engine as follows:
1. Turn the "lock OFF" switch (Fig. 20/7) to the ON position.
2. Put the choke lever (Fig. 20/C) on the position.
3. Press the petrol pump 10 times (Fig. 19).
4. Pull the recoil starter handle (2) 3 times to start the engine (Fig. 21).
Never place feet on the shaft or kneel on it.
5. Wait a while adjust the choke lever to position (Fig. 22).
6. When the engine is running and idling, press the "lock OFF" switch (7) and then
switch the throttle lever (4) on, the machine will be working (Fig. 23).
7. If any problems, press the "lock OFF" switch to OFF position, the machine will
stop running. If you need to stop the cutting head working, release the throttle
lever (Fig. 23/4).
8. If any problem occurs, pull the pin of the safety belt, then release the brush cutter
immediately (Fig. 17).
9. If the machine is hot, the throttle lever can be adjusted to ON position directly
when restarting the machine.
Note:
If the engine does not start up even after several attempts, read the section
"Engine troubleshooting".
Note:
Always pull the starter cord out in a straight line. If it is pulled out at an angle,
then friction will occur on the eyelet. As a result of this friction, the cable will become
frayed and will wear away faster. Always hold the starter handle when the cable
retracts. Never allow the cable to snap back when it has been pulled out.
Note:
Do not start the motor in tall grass.
m
ATTENTION!
When the engine has been switched off, the cutting unit continues
running for several seconds therefore do not touch the cutting unit until it has come
to a standstill!
