charging station from 23:00 and rests until it
starts cutting again at 00:00.
If the timer setting is divided into 2 work periods,
the standby period can be divided into a number
of periods. The minimum standby period time
must however be according to the Standby time
table.
24 h
A
B
Sta
nd
by
Mo
w
in
g
C
ha
rg
in
g
O
pe
ra
tio
n
R160Li
Operation, A = max. hours
23
Charging/Standby, B = min. hours
1
4.8 To charge the battery
When the product is new or has been stored for a
long period, the battery can be dead and needs
to be charged before starting. In the Main area
mode, the product automatically alternates
between mowing and charging.
WARNING: Only charge the product
using a charging station and a power
supply which is intended for it.
Incorrect use may result in electric
shock, overheating or leakage of
corrosive liquid from the battery.
In the event of leakage of electrolyte
flush with water and seek medical help
if it comes in contact with the eyes etc.
1. Set the Main switch to position
1.
2. Place the product in the charging station.
3. Open the hatch and slide the product in as
far as possible to ensure proper contact
between the product and the charging
station.
4. The display shows a message that charging
is in progress.
4.9 Adjust the cutting height
The cutting height can be varied from MIN (2 cm /
in.) to MAX (6 cm / in.).
CAUTION: During the first weeks after
a new installation, the cutting height
must be set to MAX to avoid damaging
the loop wire. After this, the cutting
height can be lowered step by step
every week until the desired cutting
height has been reached.
4.9.1 To adjust the cutting height
1. Press the STOP button to stop the product.
2. Open the hatch.
3. Turn the knob to the required position.
•
Turn clockwise to increase the cutting
height.
•
Turn counter-clockwise to decrease the
cutting height.
4. Close the hatch.
30 - Operation
1025 - 001 - 23.01.2019
