3 Installation
3.1 Introduction - Installation
WARNING: Read and understand the
safety chapter before you install the
product.
CAUTION: Only use original spare
parts and installation material.
Note: Refer to www.gardena.com for more
information about installation.
3.2 Before the installation of the wires
You can select to attach the wires with stakes or
bury them. You can use the 2 procedures for the
same work area.
•
Bury the boundary wire or the guide wire if
you are going to use a dethatcher on the
work area. If not, attach the boundary wire
or guide wire with stakes.
•
Cut the grass before you install the product.
Make sure that the grass is maximum 10
cm / 4 in.
Note: The first weeks after installation the
perceived sound level when cutting the grass
may be higher than expected. When the product
has cut the grass for some time, the perceived
sound level is much lower.
3.3 Before the installation of the
product
•
Make a blueprint of the work area and
include all obstacles.
•
Make a mark on the blueprint where to put
the charging station, the boundary wire and
the guide wire.
•
Make a mark on the blueprint where the
guide wire connects to the boundary wire.
Refer to
To install the guide wire on page
20.
•
Fill in holes in the lawn.
Note: Holes with water in the lawn can
cause damage to the product.
3.3.1 To examine where to put the charging
station
•
Keep a minimum 3 m / 5 ft. of free space in
front of the charging station.
•
Keep a minimum of 1.5 m / 5 ft. of free
space to the right and to the left of the
charging station.
•
Put the charging station near an outdoor
power outlet.
•
Put the charging station on a level surface.
max. 5 cm / 2"
max. 5 cm / 2"
•
Put the charging station in the lowest
possible section of the work area.
•
Put the charging station in an area without
an irrigation system.
•
Put the charging station in an area with
protection from the sun.
•
If the charging station is installed on an
island, make sure to connect the guide wire
page 17.
1025 - 001 - 23.01.2019
Installation - 15
