G&D VisionXS-F-DP-UHR, Инструкция по установке и эксплуатации

Страница: 181 / 216

Configuration
G&D VisionXS-F-DP-UHR · 69
English
Adjusting the operating mode of the RS232 interface
In the default setting of the extender, you can connect any RS232-compatible device
to the
optional
RS232 interface of the console module. The RS232 data stream is
transmitted unchanged to the computer module.
For transmitting RS422 signals, you can use two
G&D RS232-422 adapters
. Each of the
adapters converts the RS232 interface of the console module and the computer mod-
ule into
RS422
interfaces.
How to set the operating mode of the RS232 interface:
IMPORTANT: If you want to transmit RS422 signals, in addition to using adapters,
you also need to change the operating mode of the RS232 interfaces of both the
console and the computer module.
OSD
1. Press Ctrl+Num ( default ) to open the on-screen display.
2. Select the row Console setup and press Enter if you want to adjust the
operating mode of the RS232 interface of the console module ( CON ).
Select the row Target setup and press Enter if you want to adjust the
operating mode of the RS232 interface of the computer module ( CPU ).
3. Under RS232 port mode press F8 to select on of the following options:
RS232  The data stream of an RS232 device is transmitted from the
computer module to the console module ( default ).
RS422
 The data stream of an RS422 device is transmitted from the
computer module to the console module via separately
available
G&D RS232-422 adapters
.
4. Press
F2
to save your settings.