G&D VisionXS-F-DP-UHR, Инструкция по установке и эксплуатации

Страница: 134 / 216

Initial configuration of the network settings
22 · G&D VisionXS-F-DP-UHR
Configuring the network interface
How to configure the network interface:
1. Use the local hotkey (default: Alt + Num ) to open the local OSD to configure the net-
work interface of the console module or use the remote hotkey ( default : Ctrl + Num ) to
open the remote OSD to configure the network interface of the computer module .
2. Select the entry Network (local OSD) or Network setup (remote OSD) and press
Enter .
3. Select the entry Interfaces and press Enter .
4. Enter the following data under Interface A :
5. Press F2 to save your settings.
Operational
mode:
Press F8 to select the operational mode of the interface:

Off: switch network interface off.

Static: A static IP address is assigned.

DHCP: IP address is obtained from a DHCP server.
IP address:
Enter the IP address of the interface.
The operational mode DHCP does not allow making entries.
Netmask: Enter the netmask of the network.
The operational mode DHCP does not allow making entries.