60
Figure 45: Location of Set Screws in Enclosure End Caps
3.
Remove the enclosure end caps by rotating them counter-clockwise. To avoid binding
between the threads, gently lift the caps upwards while rotating. Make note of which side
each end cap came from in order to prevent any issues during reassembly later.
4.
With the end caps removed, locate the screws holding the component rail in place. See Figure
Figure 46: Location of Screws Holding Component Rail
5.
Remove the component rail screws by using the appropriate size hex key. The component
rail should now be loose.
6.
Locate the wiring connections shown in Figure 55. Make a note of these connections in order
to ensure correct reassembly later.
