23
Delay page
- from this page, it is possible to set the Output Channels Delay Time from 000.0000ms up to
848.9984mS, by steps of 1mS or 20.8uS.
To set the Delay time, press “ENTER”, an arrow will appear on the left of the screen “->” then use the “PM2”
encoder to set the Delay Time in steps of 1mS and the “PM3”, for setting the “fine” Delay Time in steps of
20.8 microseconds.
The following is an example screen for the “Delay” page where the Delay time of Output Channel 1 is set to
160.1872mS:
Polarity page
- from this page, it is possible to set the Output Channels Polarity, by using the “PM3”
encoder.
The polarity can be “Normal” or
“Inverted”.
The following is an example of a “Polarity” screen where the Polarity of Output Channel is set to
“Normal”:
Peak Limiter sub-menu
- from this page, it is possible to set the Output Channels Peak Limiter.
The following is an example screen for the Peak Limiter page where the Attack Time of the Peak Limiter is
set at 5ms, the Release Time is set at 0.2Sec and the Peak Limiter Active Threshold is set at +15dB:
Upon pushing “ENTER”, the Peak Limiter’s parameters can be modified using the “NAV/PM1”,
and
“PM2”
“PM3”
encoders for editing the Peak Limiter’s Attack Time [A], Release Time [R] and Active Threshold.
Once pushing “ENTER”, the above screen will change as follows:
The Attack Time [A] can be edited using the “NAV/PM1” encoder, the Release Time [R] using the “PM2”
Encoder and the Peak Limiter Active Threshold using the
encoder.
“PM3”
OutputA Left Delay
-> Delay = 160.1872mS
OutputA Left Polarity
-> Polarity = Normal
OutputA Left Limiter
A: 5ms R: 0.2s +15.0dB
OutputA Left Limiter
-> A: 5ms R: 0.2s +15.0dB
