Full Vision TRACK MASTER FVX328, Руководство пользователя

Страница: 29 / 79

TRACKMASTER Preventive Maintenance
May, 2008 FVX328 Series Owner’s Manual
6-5
Drive Belt Tension Adjustment
This procedure requires the following tool:
•
Flat screw driver
•
9/16 wrench
CAUTION Because this adjustment is not covered under your warranty, it is important that you
review these instructions thoroughly before proceeding.
Note:
The drive belt may stretch and loosen with regular use. This looseness is
noticeable when you may hear a flapping noise under treadmill hood.
1. Turn the treadmill’s power switch to OFF, unplug the treadmill from its power outlet.
Remove the three fasteners securing the hood, set hood to the side.
2. Press down on drive belt in between motor and front roller with approximately 5 lbs of force.
3. The drive belt should deflect approximately ¼” to 3/8”.
4. If deflection is more that 3/8”; see Motor Pan Assembly Appendix B for detail drawing.
5. Loosen 4 Motor mounting nuts on underside of treadmill.
6. Motor tension adjustment is located outside front.
7. Turn adjustment tension nut equally to assure drive belt alignment.
8. Make small adjustments until drive belt deflection approximately ¼” to 3/8”
DO NOT OVERTIGHTEN.