Full Vision TRACK MASTER FVX328, Руководство пользователя, Страница: 31 / 79

TRACKMASTER Preventive Maintenance
May, 2008 FVX328 Series Owner’s Manual
6-7
Running Board Removal and Maintenance
This procedure requires the following tools:
•
1/4-in. Allen wrench
•
3/16-in. Allen wrench
Running Board Removal
1. Remove the two running belt-tensioning bolts, and set bolts and end caps aside.
2. Push take-up roller against the running deck to provide as much belt slack as possible.
3. Lift the outside edges of the running belt. On each side of the running belt are two
Allen-head screws that secure the running board to the two crossbars.
4. Remove all four Allen-head screws (two per side), and pull the running board out of
the treadmill.
5. Push the deck to the right, and lift the left edge (v-guide) of the running board to
remove it. (See Frame Assembly Appendix B.)
6. Reassemble the running board by reversing the preceding five steps.
The running deck should be replaced if it is grooved.
Internal Circuit Breaker Location and Resetting
1. All circuit breakers are located at the front of the treadmill and below the hood. (See
Motor Pan Assembly Appendix B.)
•
2 ea. Power Supply / Relay Board (1/4 amp)
•
2 ea. Elevation Motor (1 amp)
2. To reset a breaker, push the button.
Note: Contact your distributor for information on possible causes of tripped circuit
breakers.