Full Boar FBDDP-7500, Инструкция по эксплуатации

Страница: 24 / 28

24
TROUBLE SHOOTING
Problem Cause Solution
Drill press will
not start.
Power cord not
connected to the mains
power supply.
Ensure that the power cord
is connected to the mains
power.
Power fault. Check the mains power
supply.
Safety guard (8) not fitted
or in the open position.
Fit and place safety guard (8)
in the “closed” position.
Power cord damage. Use an electrician or a power
tool repairer to repair or
replace.
Faulty switch or motor. Use an electrician or a power
tool repairer to repair or
replace.
V-belt cover (22) not
secured.
Check the V-belt cover (22) is
closed and lowered correctly
in position.
Drill bit burns. Incorrect speed. Adjust speed as described
in the “Setting the speed”
section (Page 19) and
“Working speed table”
(Page 21).
Excessive drill bit
wobble.
Bent or damaged drill bit. Use a new drill bit.
Drill bit is not securely
placed in the 16mm drill
chuck (16).
Remove the drill bit and
reinsert correctly, ensure
the chuck jaws are fully
tightened.
The 16mm drill chuck (16)
is not installed correctly.
Ensure you install the 16mm
drill chuck (16) correctly.
Drill bit binds in
workpiece.
Belt tension is set
incorrectly.
Re-adjust the V-belt tension.